Made of TPU material, good abrasion resistance. It is soft enough to better fit and effectively resist impact, explosion, as well as decreasing the chance of causing white edge. The film can self - repair scratches, flexible and tough elastic polymer material protective your screen from scratches and explosion. 

• TPU material, soft and durable

• Soft enough for better fit, avoiding white edge

• The protector film will show a colorful effect under the light

• Self-repair scratch, the scratches will disappear after several hours

• Anti-burst function, safe and secure

Using Steps:

• 1. Use the dry and wet alcohol bag to clean up the back of the phone,  and then use the dust sticker to stick the residual dust 

• 2. Remove the entire 1st mark white glass film

• 3. Refer to the camera hole position and the phone frame, adjust the film position, and scrape with a scratch card

• 4. Pick up the bottom of the film and the silicone under the film will deeply clean the back of the phone again

• 5. Pick up the upper film to the middle at 90 degrees to open the 2nd mark about 1cm, use the scratch card scratching the film from bottom to top and try not to pause

• 6. The other half is the same as above, the whole film is attached to the surface of the mobile phone screen

• 7. To remove the surface transparent PET film 

• 8. Use your hand or scratch card to wipe the film until there is no bubble