APM2.6 Side Pin Controller:

• Arduino Compatible

• Can be ordered with top entry pins for attaching connectors vertically, or as side entry pins to slide your connectors in to either end horizontally

• Includes 3-axis gyro, accelerometer and magnetometer, along with a high-performance barometer

• Onboard 4 MegaByte Dataflash chip for automatic datalogging

• Optional off-board GPS, uBlox LEA-6M module with Compass

• One of the first open source autopilot systems to use Invensense's 6 DoF Accelerometer/Gyro MPU-6000

• Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties

• Atmel's ATMEGA2560 and ATMEGA32U-2 chips for processing and USB functions respectively

GPS:

• Built-in compass GPS module

• Main chip: Ublox-6M

• With fast satellite searching speed and high precision

• Compatible with APM serial port and I2C port

• Includes round plastic shell and GPS support

3DR Radio Telemetry Kit 915Mhz:

• Very small and lightweight (under 4 grams without antenna)

• Available in 900MHz or 433MHz variants

• Receiver sensitivity to -121dBm

• Transmit power up to 20dBm (100mW)

• Transparent serial link

• Air data rates up to 250kbps

• Range of approx. 1 mile

• MAVLink protocol framing and status reporting

• Frequency hopping spread spectrum (FHSS)

• Adaptive time division multiplexing (TDM)

• Support for LBT and AFA

• Configurable duty cycle

• Built in error correcting code (can correct up to 25% data bit errors)

• Demonstrated range of several kilometers with a small omni antenna

• Can be used with a bi-directional amplifier for even more range

• Open source firmware

• AT commands for radio configuration

• RT commands for remote radio configuration

• Adaptive flow control when used with APM

• Based on the HopeRF HM-TRP radio module, featuring an SiLabs Si1000 RF microcontroller

MAVLink-OSD V2.0:

• MAVLink-OSD is an Arduino based project and it is fully compatible with original MinimOSD

• This board can be used for CRIUS AIOP and Arduflyer / ArduPilot-Mega

• MAVLink-OSD with switching DC/DC step-down power supply to maximize efficiency on power system. No more heating problems when using this OSD board

Power Module:

• Hardware:

• ATMEGA328P Microcontroller

• MAX7456-EUI monochrome on-screen display

• 5V/500mA DC/DC regulator for MAX7456-EUI

• Operating voltage: 5V(FTDI connector) and 12V(Video I/O connector)

• Supported NTSC & PAL

• FTDI connector

• Software:

• Full MAVLink protocol support

• Graphical configurator tool

• Note: The Power Module is only designed to power APM/Arduflyer, a RC receiver and accessories (GPS, Radio telemetry). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.

APM Arduflyer Power Module V1.0:

• Max input voltage: 30V

• Max current sensing: 90A

• Voltage and current measurement configured for 5V ADC

• Switching regulator outputs 5.3V and 3A max

• 6P molex cable plugs directly to APM/Arduflyer 2.5's PM connector

• Dimension: 25mm x 21mm x 9mm